The device, service, repair of Honda Civic and Acura Integra - the Electric drive of window regulators – general information and check of serviceability of functioning//since 1994 release /

Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   General information and precautionary measures
   Search of causes of failures of electric equipment
   Safety locks - the general information
   Chain breakers
   The relay - the general information and check of serviceability of functioning
   Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
   Check of serviceability of functioning and replacement of understeering switches
   Check of serviceability of functioning and replacement of the switch of ignition and lock of blocking of a steering column
   Check of serviceability of functioning and replacement of switches of the dashboard
   Check of serviceability of functioning of measuring instruments of a combination of devices
   Removal and installation of a combination of devices
   Removal and installation of the radio receiver and loudspeakers
   Removal and installation of the antenna of the radio receiver
   Replacement of lamps of head headlights
   Adjustment of the direction of optical axes of head headlights
   Replacement of block headlights
   Replacement of lamps
   Running fires of light time of day (DRL)
   Check of serviceability of functioning and replacement of an electric motor of the drive of screen wipers
   Check of serviceability of functioning and replacement of a horn of a horn
   Check of serviceability of functioning and recovery repair of a heater of back glass
   Control system of speed (tempostat) - general information and check of serviceability of functioning
   The electric drive of window regulators - general information and check of serviceability of functioning
   The uniform lock - general information and check of serviceability of functioning
   The electric drive of external rear-view mirrors - general information and check of serviceability of functioning
   Safety cushions - the general information
   + Schemes of electric connections - the general information





The electric drive of window regulators – general information and check of serviceability of functioning

The control system of functioning of window regulators consists of switches of management, driving electric motors, regulators of window regulators, mechanisms of lowering lifting of glasses and a connecting electrical wiring. Electric motors of the drive of window regulators are located in car doors.

Control of window regulators can be exercised from a driver's place by means of the main switch, or by means of manipulations with individual door switches. Each of glasses is equipped with an individual driving electric motor of reversive type. Switching of a key of the switch polarity of connection of the motor and, as a result, the direction of its rotation changes.

The contour is protected by a safety lock and the breaker of a chain. Each of electric motors is in addition equipped with the individual breaker preventing possibility of a conclusion out of operation of all system when jamming separate glass.

The electric drive of window regulators functions only at the included ignition. In addition on many models possibility of blocking of window regulators back (and sometimes and a lobby passenger) doors from the main switch is provided. Do not forget about this function when checking refusals of screen wipers.

The described procedures have the most general character therefore if their performance does not allow to establish unambiguously a cause of failure, drive away the car for more detailed diagnostics on car repair shop.

  • In case of refusal window regulators always first of all check a condition of a safety lock and the breaker of a chain.
  • If window regulators of back doors cope only from the main switch, check conductivity of the blocking switch in the released state. Replace the faulty switch.
  • Check a condition of an electrical wiring on a chain site between switches and the assembly block of safety locks. Make necessary repair.
  • At refusal of functioning of the main switch of only one of glasses, check serviceability of operation of this window regulator from other switch.

    The last does not belong to a window regulator of a driver's door.


  • If the same window regulator regularly works from other switch, check conductivity of the switch.
  • If the switch as it should be, check for break and short circuit a chain on a site between the suspected switch and a driving electric motor of this window regulator.
  • If the window regulator does not work from both switches, remove the panel of an internal upholstery from this door and check existence of tension both on the switch, and on the driving motor (at the relevant provision of the switch) (see an accompanying illustration).

Card of conditions of the main switch of management of door window regulators (Civic Compartment/hatchback)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

Left forward (driver's) door The driver's switch is not subject to check
Right forward door
   OFF. A2, A5 and A7
   UP A2 and A5; A6 and A7
   DOWN A2 and A6; A5 and A7
CHECK IS MADE AT THE BLOCKING SWITCH WHICH IS SWITCHED ON MAIN

Card of conditions of the main switch of management of door window regulators (Civic Sedan)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

Left forward (driver's) door The driver's switch is not subject to check
Right forward door
   OFF. B1, B11 and C1
   UP B1 and B2; B11 and C1
   DOWN B2 and B11; B1 and C1
Left back door
   OFF. B14, B16 and C1
   UP B14 and B15; B16 and C1
   DOWN B15 and B16; B14 and C1
Right back door
   OFF. B9, B10 and C1
   UP B8 and B9; B10 and C1
   DOWN B8 and B10; B9 and C1
CHECK IS MADE AT THE BLOCKING SWITCH WHICH IS SWITCHED ON MAIN

The card of conditions of the switch of management of window regulators of a passenger door (Civic, including switches of back doors on the Sedan models)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

INCL. 2 and 3; 4 and 5
UP 1 and 4; 2 and 3
DOWN 1 and 3; 4 and 5

Card of conditions of the main switch of management of door window regulators (Integra Hatchback)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

Left forward (driver's) door The driver's switch is not subject to check
Right forward door
   OFF. D, N and I
   UP D and N; I and J
   DOWN D and I; N and J
CHECK IS MADE AT THE BLOCKING SWITCH WHICH IS SWITCHED ON MAIN

Card of conditions of the main switch of management of door window regulators (Integra Sedan)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

Left forward (driver's) door The driver's switch is not subject to check
Right forward door
   OFF. I, J and Q
   UP N and J; I and Q
   DOWN N and I; J and Q
Left back door
   OFF.

F, G and Q

   UP

E and G; F and Q

   DOWN

E and F; G and Q

Right back door
   OFF. O, P and Q
   UP N and P; About and Q
   DOWN N and O; P and Q
CHECK IS MADE AT THE BLOCKING SWITCH WHICH IS SWITCHED ON MAIN

Card of conditions of the switch of management of a window regulator of back doors (Integra Sedan)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

INCL. A and B; C and E
UP A and B; D and E
DOWN B and D; C and E

Card of conditions of the switch of management of a window regulator of a forward passenger door (Integra Hatch-back and Sedan)


POSITION OF THE SWITCH

EXISTENCE OF CONDUCTIVITY BETWEEN PLUGS

INCL. A and B; D and E
UP B and C; D and E
DOWN A and B; C and D
  • For an assessment of a condition of the switch check it according to the provided instructions.
  • At correct giving of food on an electric motor separate glass from the window regulator regulator (see the Head Kuzov). Move glass up-down, checking freedom of its movement. Also check serviceability of a condition of the regulator. If the regulator in norm, and glass freely moves in both directions, replace a driving electric motor. At violation of smoothness of movement of components eliminate the found hindrances, grease the rubbing knots and replace the damaged details.

The driving electric motor is built in assembly of the regulator of a window regulator, the description of which procedure of removal is provided in the Head Kuzov.

  • If food on the motor does not move, check for conductivity existence an electrical wiring on a chain site between switches and motors (in case of need address to schemes of electric connections at the end of the present Chapter). If the contour is equipped with the executive relay, check serviceability of food and grounding of the last.
  • Having made necessary corrections, repeat check of functioning of window regulators.