|
Honda Civic/Acura Integrasince 1994 releaseRepair and operation of the car |
|
Honda Tsivik + Cars of the Honda Civic and Acura Integra brand + Maintenance instruction + Routine maintenance + Engine + Cooling system and heating + Power supply system and release - Electric equipment of the engine Specifications Start of the engine from the auxiliary power supply Check of a state and replacement of the battery Check of a state and replacement of wires of the battery System of ignition - the general information Check of functioning of system of ignition Check of a state and replacement of the coil of ignition Check of serviceability of functioning and replacement of the module of management of ignition (ICM) Removal and installation of the distributor of ignition Check of installation and adjustment of a corner of an advancing of ignition System of a charge - the general information and precautionary measures Check of a condition of system of a charge Removal and installation of the generator Replacement of the regulator of tension and brushes of the generator System of start - the general information and precautionary measures Check of serviceability of functioning of a starter on the car (in situ) Removal and installation of a starter Removal and installation of the traction relay + Control systems of the engine + gear shifting Box + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment |
Electric equipment of the engine General information and precautionary measures Components of systems of ignition, charge and start are a part of electric equipment of the engine (see illustrations below). In view of the fact that these systems have a direct bearing on operation of the engine, they are considered separately from other onboard electric equipment, such as signal and lighting lights, monitors, etc., to placement, a design and to which principles of functioning the Head Onboard electric equipment is devoted.At service of components of systems of electric equipment it is necessary to observe special precautionary measures in order to avoid risk of failure of semiconductor elements, and also for the purpose of prevention of receiving electric traumas. Starting service of electric equipment surely remove a watch, rings and other metal jewelry. Even at the disconnected battery the category of condensers at casual grounding of their plugs can lead to receiving electric shock or a strong burn. Do not allow violation of polarity at connection of the battery. In structure of such components as the generator, or electronic control units enter semiconductor elements which can be put out of action at the wrong connection of wires. When performing start of the engine from the external power supply, or connection of the charger also observe polarity of connection of wires (see appropriate section in Introduction to the present manual). Never disconnect an electrical wiring from the battery, the generator or the diagnostic equipment at the working engine. Do not allow a provorachivaniye the engine of the disconnected generator. Do not make verification of output tension of the generator by grounding of its plugs at all. Do not apply to verification of conductivity in a chain the ohmmeters equipped manual with a dynamo car. When performing any works on service of electric equipment watch that the negative wire was disconnected from the battery. Before use of arc welding without fail disconnect the battery, the generator and such components, as RSM of systems of food/ignition in order to avoid risk of their damage The scheme of an arrangement of components of electric equipment of the engine in a motor compartment of the car (Civic) The scheme of an arrangement of components of electric equipment of the engine in a motor compartment of the car (Civic) |
|