Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
- Electric equipment of the engine
   Specifications
   Start of the engine from the auxiliary power supply
   Check of a state and replacement of the battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information
   Check of functioning of system of ignition
   Check of a state and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management of ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and installation of the generator
   Replacement of the regulator of tension and brushes of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and installation of a starter
   Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the traction relay

On the Integra models the starter of production of the Nippondenso company with the fixed traction relay is used. In case of failure all assembly is subject to replacement. The description given below belongs to Mitsubishi starters.


 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!


2. Remove a starter (see Removal and installation of a starter).
3. Disconnect the big wire connecting the traction relay to the starter electric motor plug.

4. Turn out long bolts of fastening of a face cover to a reducer casing (see an accompanying illustration). Remove the case of anchor assembly.

5. Turn out fixing screws and separate a reducer casing from a forward cover of assembly (see an accompanying illustration).

6. Turn out fixing screws and separate a reducer casing from the traction relay (see an accompanying illustration).

7. Installation is made upside-down. Before assembly grease the lever of the drive and a plunger of the traction relay with assembly greasing (see an accompanying illustration).