Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
- Electric equipment of the engine
   Specifications
   Start of the engine from the auxiliary power supply
   Check of a state and replacement of the battery
   Check of a state and replacement of wires of the battery
   System of ignition - the general information
   Check of functioning of system of ignition
   Check of a state and replacement of the coil of ignition
   Check of serviceability of functioning and replacement of the module of management of ignition (ICM)
   Removal and installation of the distributor of ignition
   Check of installation and adjustment of a corner of an advancing of ignition
   System of a charge - the general information and precautionary measures
   Check of a condition of system of a charge
   Removal and installation of the generator
   Replacement of the regulator of tension and brushes of the generator
   System of start - the general information and precautionary measures
   Check of serviceability of functioning of a starter on the car (in situ)
   Removal and installation of a starter
   Removal and installation of the traction relay
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of the regulator of tension and brushes of the generator

On all Civic models and some Integra models of 1998 vyp. generators of production of the Mitsubishi company are used. Replacement of brushes and the regulator of tension demand full dismantling of the generator here and have to be charged to specialists of car service.

Replacement of brushes and the regulator of tension on Nippondenso generators can be made by own forces of the amateur mechanic, however it is not necessary to make attempts of independent performance of complete recovery repair of the generator. It will be simpler to replace assembly.


 PERFORMANCE ORDER

1. Remove the generator from the car (see Removal and installation of the generator) and transfer it to a workbench.

2. Give three fixing nuts and remove a back cover of the generator (see an accompanying illustration).

3. Give two screws of fastening of the brush holder (see an accompanying illustration).

4. Remove the brush holder from a back end face of the generator.

5. Measure length of a vystupaniye of each of brushes from the holder (see an accompanying illustration) and compare results of measurements to requirements of Specifications. If the size of a vystupaniye of brushes is less than lower bound of admissible range, make their replacement.

6. Check freedom of the course of brushes in the holder's cartridges.

7. For replacement of the regulator of tension it is necessary to remove assembly of the brush holder previously. Then give fixing screws (see an accompanying illustration) and remove the regulator from the generator.

8. Installation is made upside-down. At installation to the place of the brush holder wring out brushes for a shaft transmission a small screw-driver.