Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
- Coupling and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Check of a state and replacement of the directing bearing
   Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check of a state and replacement of the directing bearing

As the directing bearing of coupling the ball-bearing pressed in a flywheel is used. The bearing is executed tight and filled by greasing at manufacturer. A problem of the bearing is fixing of the forward end of a pin of primary shaft of a transmission. Check of a condition of the bearing has to be made every time at removal of coupling from the engine. In view of the inaccessibility the directing bearing should be changed at the slightest doubts in an assessment of its state.

If the engine is removed from the car and installed on a workbench / the assembly stand, procedures described in the following paragraphs should be lowered.


 PERFORMANCE ORDER

1. Remove a transmission (see a 5-staged manual box of gear shifting).
2. Remove coupling components (see Removal, check of a state and installation of components of assembly of coupling).
3. By means of a small lamp survey the bearing on existence of signs of excessive wear, signs of drying of greasing, cracks, zadir and other mechanical damages. In case of detection of this sort of defects replace the bearing.

4. Extraction of the bearing can be made by means of a small stripper with the sliding freight (see an accompanying illustration).

5. In the absence of near at hand stripper remove a flywheel (see Repair of the engine without extraction from the car - the Civic model), then by means of a hammer and a drift beat out the bearing from the landing nest (knocking-out make from the back party of a flywheel forward).

6. Before installation of the new bearing slightly grease it outside with greasing. As a mandrel the face head will be suitable for landing of the bearing, diameter there is slightly less than outer diameter of the bearing (see an accompanying illustration).

7. Establish into place a flywheel (see Repair of the engine without extraction from the car - the Civic model). Establish coupling assembly, a transmission and the other components which were removed for the purpose of ensuring access. Tighten all fixture with the corresponding effort.