Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
- Coupling and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Check of a state and replacement of the directing bearing
   Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling

Remember that the dust developed in the course of wear of frictional overlays of the conducted coupling disk may contain unhealthy asbestos. Do not blow off dust compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis, – use only special brake cleaners or pure methyl alcohol. Put the used rags in hermetically closed container.

Removal

 PERFORMANCE ORDER

1. Otboltite the executive cylinder of coupling (see Removal and installation of the executive cylinder of coupling), without disconnecting from it the hydraulic line going from the main cylinder. Tie up the cylinder aside a wire.
2. Remove a transmission (see a 5-staged manual box of gear shifting).

3. Remove from a pin of primary shaft vyzhimny the bearing, disconnect the holding spring of a fork of switching off of coupling from a spherical finger of a spherical support and remove a fork (see an accompanying illustration).

Check

 PERFORMANCE ORDER

1. Holding the bearing for an external holder, press internal and rotate it (see an accompanying illustration). The bearing has to rotate freely and silently, otherwise it needs to be replaced.

2. Wipe the bearing pure rags and examine on existence of signs of wear, cracks and other mechanical damages. Usually replacement of the vyzhimny bearing is made every time at service of components of coupling. Do not wash out the bearing in solvent in order to avoid violation of tightness of its assembly at all. Also check the lever of switching off of coupling for existence of cracks and signs of deformations.

Installation

 PERFORMANCE ORDER

1. Fill an internal flute of the vyzhimny bearing refractory greasing. Slightly grease with the same greasing vents of a pin of primary shaft of a transmission and the holder of the bearing of the last (see an accompanying illustration).

2a. Grease with the same greasing a nest under landing of a spherical finger from a reverse side of a fork of switching off...

2b.... and also a nest under landing of a pusher of the executive cylinder (see accompanying illustrations).

2c. Grease a spherical finger of a spherical support of the lever of inclusion.

3. Enter vyzhimny the bearing into gearing with a coupling switching off fork.
4. Put on the bearing on the holder of the forward bearing of primary shaft of a transmission, at the same time spending the end of a fork of switching off through an opening in a coupling casing. Densely put a switching off fork on a sharovy finger of a spherical support.
5. Slightly grease with refractory greasing the surface of the vyzhimny bearing contacting to petals of a diaphragm spring.
6. Further installation is made as it should be, the return to a dismantle order.