Honda Tsivik + Cars of the Honda Civic and Acura Integra brand + Maintenance instruction + Routine maintenance + Engine + Cooling system and heating + Power supply system and release + Electric equipment of the engine + Control systems of the engine + gear shifting Box - Coupling and power shafts Specifications Coupling - the general information and check of a condition of components Removal and installation of the main cylinder of coupling Removal and installation of the executive cylinder of coupling Removal of air from a hydraulic path of the drive of switching off of coupling Removal, check of a state and installation of components of assembly of coupling Check of a state and replacement of the directing bearing Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling Adjustment of a pedal of coupling Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter Removal and installation of power shafts Removal and installation of an intermediate shaft (Integra model) Replacement of protective covers and check of a condition of CV JOINTS + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
Check
|
1. The sensor switch of disconnection of a chain of a starter is located near the top end of a pedal of coupling (see an illustration). To the sensor switch two wires, one – from the relay of inclusion of a starter, by the second – are brought to weight. When turning the ignition key in the situation START and squeezing of a pedal of coupling, due to operation of the sensor switch, there is a short circuit on the mass of the relay of a starter that leads to activation of an electric motor of the last. 2. If the engine is not turned at the squeezed-out coupling pedal, it is necessary to make adjustment of the sensor switch (see below Adjustment), then to repeat attempt. If adjustment does not help to achieve desirable result, check a condition of the sensor switch (see paragraph 3) and in case of need replace the last (see below Replacement). 3. If when squeezing a pedal of coupling the engine is not turned, therefore, or conductivity between sensor switch plugs is broken, or on the last power supply from the starter relay does not move. 4. Check serviceability of giving of food by means of the voltmeter or a lamp sampler. When turning the ignition key in the situation START and squeezing of a pedal on the wire going from the relay of a starter tension has to take place. If tension is absent, check for break an electrical wiring between the relay and the sensor switch. If food moves regularly, check existence of tension from the opposite side of the sensor switch (at the squeezed-out coupling pedal). Existence of tension from both parties of the sensor switch confirms serviceability of its functioning. Try to make adjustment (see below Adjustment). In the absence of tension replace the sensor switch. |
|
Replacement
|
1. Disunite the electrical wiring socket, weaken an adjusting nut and turn out the sensor switch from the arm. Installation is made upside-down. |
|
Adjustment
|
1. Weaken a lock-nut and, rotation of the sensor switch achieve existence of conductivity between its plugs at the squeezed-out coupling pedal. |
|
|
|