Honda Tsivik + Cars of the Honda Civic and Acura Integra brand + Maintenance instruction + Routine maintenance + Engine + Cooling system and heating - Power supply system and release Specifications Dropping pressure in a power supply system Check of serviceability of functioning of the fuel pump/pressure of fuel Check of a state and replacement of fuel lines and their nipple connections Removal and installation of the fuel pump Check of a state and replacement of the sensor of fuel consumption Removal and installation of a fuel tank Cleaning and repair of a fuel tank - general information Removal and installation of assembly of the air cleaner Removal, installation and adjustment of a cable of an accelerator System of electronic injection of fuel (EFI) - the general information Check of serviceability of functioning of system of injection Removal and installation of the case of a throttle Removal and installation of the regulator of pressure of fuel Removal and installation of the fuel highway and injectors of fuel of injectors of fuel System of release - the general information + Electric equipment of the engine + Control systems of the engine + gear shifting Box + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment
|
Removal and installation of the fuel pump
|
1. Disconnect a negative wire from the battery.
|
If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action! |
2. Dump pressure in a power supply system (see Dropping pressure in a power supply system). 3. On all models, except Integra the Hatchback of 1998 vyp., remove a back seat (see the Head Kuzov). On the models Integra Hatchback of 1998. vyp. remove a spare wheel and a protective cover.
|
4a. Turn out bolts of fastening of a cover of access to a fuel tank to assembly of a gasoline pump (see silt.: Civic models). |
|
4b. Fastening bolts – the Integra models. |
|
5. Disconnect an electrical wiring from assembly. By means of two wrenches disconnect fuel lines (see an accompanying illustration). |
|
6. Give nuts of fastening of the pump (see an accompanying illustration). |
|
7. Carefully take assembly from a fuel tank (see an accompanying illustration). |
|
8. Remove a protective cover of the main electric socket (see an accompanying illustration). |
|
9. Disunite the main electric socket of assembly of the fuel pump (see an accompanying illustration). |
10. Flat-nose pliers squeeze clips of fastening of a fuel hose – remove the top clip, lower shift to the middle of a hose, having completely released the pump union. 11. Disconnect the pump from a basic arm.
|
12. Remove from the lower end face of assembly the filtering element (see an accompanying illustration). |
13. Installation is made upside-down. Do not forget to replace sealing laying of a landing flange of a cover of access to a fuel tank. |
|
|
|