Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
- Coupling and power shafts
   Specifications
   Coupling - the general information and check of a condition of components
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of the drive of switching off of coupling
   Removal, check of a state and installation of components of assembly of coupling
   Check of a state and replacement of the directing bearing
   Removal, check of a state and installation of the vyzhimny bearing and fork of switching off of coupling
   Adjustment of a pedal of coupling
   Check of a state, replacement and adjustment of the sensor switch of disconnection of a chain of a starter
   Removal and installation of power shafts
   Removal and installation of an intermediate shaft (Integra model)
   Replacement of protective covers and check of a condition of CV JOINTS
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Coupling and power shafts

General information

The present Chapter is devoted to the components located between back part of the engine and driving wheels of the car (without transmission which is considered in the Head Korobka of gear shifting). According to the destination the considered components can be broken into two categories – coupling and power shafts. Descriptions of a design and the principle of action of each of separate knots and components, and also procedures of check of a state, removal, dismantling and recovery repair of the details entering into both groups are provided in the following Sections.

As the most part of the procedures described in the present Chapter is made under the car, the special attention should be paid to reliability of fixing of the last in the lifted situation.