Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car


Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
- Power supply system and release
   Specifications
   Dropping pressure in a power supply system
   Check of serviceability of functioning of the fuel pump/pressure of fuel
   Check of a state and replacement of fuel lines and their nipple connections
   Removal and installation of the fuel pump
   Check of a state and replacement of the sensor of fuel consumption
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - general information
   Removal and installation of assembly of the air cleaner
   Removal, installation and adjustment of a cable of an accelerator
   System of electronic injection of fuel (EFI) - the general information
   Check of serviceability of functioning of system of injection
   Removal and installation of the case of a throttle
   Removal and installation of the regulator of pressure of fuel
   Removal and installation of the fuel highway and injectors of fuel of injectors of fuel
   System of release - the general information
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a fuel tank

See preventions at the beginning Dropping pressure in a power supply system.


Procedure performance considerably becomes simpler if beforehand to devastate a gasoline tank.


 PERFORMANCE ORDER

1. For the purpose of dumping of excessive pressure uncover a jellied mouth of a fuel tank.
2. Dump residual pressure in a power supply system (see Dropping pressure in a power supply system).
3. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for input of the audio system in action!


4. Turn out a drain stopper and lower the fuel which remained in a tank in the prepared capacity of suitable volume (see an accompanying illustration). If the drain stopper is not provided, pump out fuel by means of a special set which can be got practically in any shop of automobile accessories.


Do not suck away gasoline a mouth at all!


5. Remove a back seat (see the Head Kuzov) and disconnect an electrical wiring from the sensor of fuel consumption and the fuel pump (see Check of a state and replacement of fuel lines and their nipple connections and Removal and installation of the fuel pump). Also disconnect from the pump fuel hoses (see Check of a state and replacement of fuel lines and their nipple connections).
6. A car back also establish to Poddomkratta it on props.

7a. Remove protective panels of a gasoline tank and fuel lines. On the Civic models one big panel is used.

7b. On the Integra models – two small (see accompanying illustrations).

8. Mark and disconnect fuel hoses and arms of their fastening on a tank (see an accompanying illustration).

9. Prop up a fuel tank a floor jack. For distribution of loading lay a strong wooden bar between a head of a jack and the bottom of a tank.

10. Give bolts of fastening of both assembly brackets of a fuel tank (see an accompanying illustration).

11. Lower brackets and take a tank from under the car.
12. Installation is made upside-down.