Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of assembly of the forward shock-absorber with a screw spring
   Replacement of the shock-absorber or screw spring of rack-mount assembly of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross stability with basic plugs
   Removal and installation of the top control lever of a forward suspension bracket
   Removal and installation of the lower control lever of a forward suspension bracket
   Removal and installation of a rotary fist and stupichny assembly
   Removal and installation of assembly of a forward nave with the wheel bearing
   Replacement of spherical support
   Removal and installation of assembly of the back shock-absorber with a screw spring
   Removal and installation of a bar of the back stabilizer of cross stability with basic plugs
   Removal and installation of assembly of a back nave with the wheel bearing
   Removal and installation of levers of a back suspension bracket
   Removal and installation of a steering wheel
   Removal and installation of tips of steering drafts
   Replacement of protective covers of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Removal of air from a hydraulic path of system of strengthening of a wheel
   Wheels and tires - the general information
   Corners of installation of wheels
+ Body
+ Onboard electric equipment




Removal and installation of assembly of a back nave with the wheel bearing

The back nave is combined with the wheel bearing in uniform assembly. The bearing is sealed at manufacturer and additional greasing does not need. In case of wear or damage of the bearing it is necessary to replace all stupichny assembly.


 PERFORMANCE ORDER

1. Weaken nuts of fastening of the corresponding back wheel. A car back also establish to Poddomkratta it on props. Remove a wheel.
2. Remove a brake drum / support with a disk (see the Head Brake system).

3. By means of a hammer and a chisel remove a dustproof cover (see an accompanying illustration).

4a. To Raschekanta a stupichny (shpindelny) nut (see an accompanying illustration), then give it, remove a persistent washer and a nave of a wheel.

4b. The nave has to be removed rather freely, in case of difficulties use a stripper on the basis of a hammer with sliding brisk (see an accompanying illustration).

5. Establish new stupichny assembly and a persistent washer. Tighten a new stupichny nut with the demanded effort. Do not forget to fuller a nut (see an accompanying illustration).

6. Establish into place a dustproof cover, for reliability of landing having slightly tapped it on perimeter.
7. Further installation is made as it should be, the return to an order of dismantle of components.