Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
- Control systems of the engine
   Specifications
   System of onboard diagnostics (OBD) - the principle of functioning and codes of malfunctions
   Removal and PCM/ECM installation
   Check of serviceability of a state and replacement of the sensor of provision of a butterfly valve (TPS)
   Check of serviceability of a state and replacement of the sensor of absolute pressure in the pipeline (MAR)
   Check of serviceability of a state and replacement of the sensor of temperature of the soaked-up air (IAT)
   Check of serviceability of a state and replacement of the sensor of temperature of cooling liquid of the engine (eats)
   Check of serviceability of a state and replacement of the sensor of VMT/provision of a cranked shaft / situation of pistons in cylinders of the engine (TDC/CKP/CYP)
   Check of serviceability of a state and replacement of the sensor of fluctuations of a cranked shaft (CKF)
   Check of serviceability of a state and replacement of the detector of control of electric loadings (ELD)
   Check of serviceability of a state and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP)
   Check of serviceability of a state and replacement of the oxygen sensor (l-probe)
   Check of serviceability of a state and replacement of the sensor of a detonation
   Check of serviceability of a state and replacement of the sensor of speed of the movement of the car (VSS)
   System of stabilization of turns of idling - the general information, check of a state and replacement of the IAC valve
   Check of serviceability of a state and replacement of the thermosensitive valve of turns of fast idling (FIT)
   System of a perepuskaniye of the soaked-up air - the general information, check of a state and replacement of a diaphragm of the IAB valve
   System of the operated ventilation of a case (PCV)
   System of recirculation of the fulfilled gases (EGR) - the general information, check of a state and replacement of components
   System of catching of fuel evaporations (EVAP) - the general information, check of a state and replacement of components
   The catalytic converter - the general information, check of a state and replacement
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check of serviceability of a state and replacement of the sensor of temperature of the soaked-up air (IAT)

Check

 PERFORMANCE ORDER

1. At the included ignition disconnect an electrical wiring from the IAT sensor located on the inlet pipeline (see an accompanying illustration). By means of an ohmmeter measure resistance between two plugs on the sensor. Resistance of the sensor depends on temperature (see the accompanying table).


Temperature, °C

Resistance, Ohm

- 20

12

0

5

20

2

40

1

80

0.5

101 0.4

121

0.2


2. At the included ignition (do not start the engine) measure basic tension on sensor electrical wiring socket plugs (a red-yellow wire) (see an illustration above). The result of measurement has to make about 5 V, otherwise walk on a wire to ECM/PCM, checking it for existence of breaks and fastening of contact connections.
3. If an electrical wiring as it should be, replace the IAT sensor.
4. If replacement of the sensor does not lead to elimination of a problem, the car should be driven away on car repair shop for performance of diagnostics of ECM/PCM.

Replacement

 PERFORMANCE ORDER

1. Disconnect from the sensor an electrical wiring (see illyustr. above).
2. Turn out fixing screws and remove the sensor from the inlet pipeline.
3. Installation is made upside-down.