Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
+ Engine
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
- Control systems of the engine
   Specifications
   System of onboard diagnostics (OBD) - the principle of functioning and codes of malfunctions
   Removal and PCM/ECM installation
   Check of serviceability of a state and replacement of the sensor of provision of a butterfly valve (TPS)
   Check of serviceability of a state and replacement of the sensor of absolute pressure in the pipeline (MAR)
   Check of serviceability of a state and replacement of the sensor of temperature of the soaked-up air (IAT)
   Check of serviceability of a state and replacement of the sensor of temperature of cooling liquid of the engine (eats)
   Check of serviceability of a state and replacement of the sensor of VMT/provision of a cranked shaft / situation of pistons in cylinders of the engine (TDC/CKP/CYP)
   Check of serviceability of a state and replacement of the sensor of fluctuations of a cranked shaft (CKF)
   Check of serviceability of a state and replacement of the detector of control of electric loadings (ELD)
   Check of serviceability of a state and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP)
   Check of serviceability of a state and replacement of the oxygen sensor (l-probe)
   Check of serviceability of a state and replacement of the sensor of a detonation
   Check of serviceability of a state and replacement of the sensor of speed of the movement of the car (VSS)
   System of stabilization of turns of idling - the general information, check of a state and replacement of the IAC valve
   Check of serviceability of a state and replacement of the thermosensitive valve of turns of fast idling (FIT)
   System of a perepuskaniye of the soaked-up air - the general information, check of a state and replacement of a diaphragm of the IAB valve
   System of the operated ventilation of a case (PCV)
   System of recirculation of the fulfilled gases (EGR) - the general information, check of a state and replacement of components
   System of catching of fuel evaporations (EVAP) - the general information, check of a state and replacement of components
   The catalytic converter - the general information, check of a state and replacement
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Check of serviceability of a state and replacement of the sensor switch of pressure in system of hydrostrengthening of a wheel (PSP)

The PSP sensor switch is used on the models which are let out for the market of the USA and is normally closed key. The sensor switch is switched on in the hydraulic line and located near a case of rack transfer. At strong turns of a steering wheel (for example during a parking or at abrupt turns) pressure considerably increases in system of hydrostrengthening also the PSP sensor switch, being disconnected, informs on this ECM/PCM which as appropriate lifts idling turns, compensating the increasing load of the engine. At violations of functioning of the sensor switch the system of self-diagnostics of OBD brings the corresponding code of malfunction in memory of the processor.

Check

 PERFORMANCE ORDER

1. If the engine becomes deaf at commission of maneuvers during a car parking, check serviceability of functioning of the PSP sensor switch. Malfunction of the sensor switch can lead as well to constantly raised engine turns.
2. Disconnect an electrical wiring from the sensor switch.

3. Connect an ohmmeter to sensor plugs (see an accompanying illustration).

5. Start the engine on single turns.
6. Bring lobbies of wheels of the car into rectilinear situation and consider the indication of an ohmmeter which in this case has to be close to zero.
7. Rotating a steering wheel in any direction, watch indications of the measuring instrument. At approach of a steering wheel to any of extreme provisions the PSP sensor switch has to be disconnected that is confirmed by the infinite indication of an ohmmeter.
8. At negative results of check replace the sensor switch. If the sensor switch is serviceable, it is necessary to check settings of single turns of the engine.

Replacement

 PERFORMANCE ORDER

1. Disconnect both wires from the battery.

The negative wire always has to be disconnected first of all and be connected in the last. If the stereosystem established on the car is equipped with a security code before disconnecting the battery make sure that have the correct combination for introduction of the equipment to action!


2. In case of need a car front also establish to a poddomkratta it on props.
3. Disconnect an electrical wiring from the sensor switch and turn out the last from the nipple connection.
4. Establish to the place of the left sensor switch replaceable and lower the car on the earth.
5. Remove from a hydraulic path of system of the steering amplifier air traffic jams (see the Head Podvesk and a steering). In case of need correct liquid level (see the Head Routine maintenance).