Honda Civic/Acura Integra

since 1994 release

Repair and operation of the car



Honda Tsivik
+ Cars of the Honda Civic and Acura Integra brand
+ Maintenance instruction
+ Routine maintenance
- Engine
   + Repair of the engine without extraction from the car - the Civic model
   + Repair of the engine without extraction from the car - the Integra model
   - General and capital repairs of the engine
      General information
      Check of pressure of oil
      Check of compression pressure in cylinders
      Diagnostics of a condition of the engine with use of the vacuum gage
      Removal from the car of the power unit - preparation and precautionary measures
      Removal and installation of the engine
      Alternative versions of schemes of recovery repair of the engine
      Order of dismantling of the engine by preparation it to capital repairs
      Dismantling of a head of cylinders
      Cleaning and check of a condition of a head of cylinders
      Service of valves
      Assembly of a head of cylinders
      Removal of shatunno-piston assemblies
      Removal of a cranked shaft
      Cleaning of the block of the engine
      Check of a condition of the block of the engine
      Honingovaniye of mirrors of cylinders
      Check of a condition of components of shatunno-piston group
      Check of a condition of a cranked shaft
      Check of a state and selection of inserts of radical and shatunny bearings of a cranked shaft
      Engine assembly order
      Installation of piston rings
      Installation of a cranked shaft and check of working gaps of radical bearings
      Replacement of a back epiploon of a cranked shaft
      Installation of shatunno-piston assemblies and check of size of working gaps in shatunny bearings of a cranked shaft
      Trial start and running in of the engine after capital repairs
+ Cooling system and heating
+ Power supply system and release
+ Electric equipment of the engine
+ Control systems of the engine
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Service of valves

In view of complexity of kind of work and need of use of the special equipment, service of valves, the directing plugs and saddles it will be most correct to charge them to the personnel of car service.

By own forces of the owner of the car such procedures as dismantling of a head, primary cleaning and check of a condition of components of the valvate mechanism can be made. Then it is necessary to collect and deliver a head for professional service in a workshop of car service. Thus rather fair idea of the volume of subjects to performance of work usually is formed and the approximate list of necessary replaceable components can be prepared.

Experts of a workshop will remove valves and valvate springs from a head and will make necessary recovery repair or replacement of worn-out components (valves, their saddles, the directing plugs, springs, plates of springs and crackers of cutting locks). Replacement of maslootrazhatelny caps is without fail made. After assembly of components the adjusting height of valvate springs will be checked. In case of need experts will make a head pro-point for the purpose of restoration of planeness of its interfaced surface.

After completion of professional repair of a head its state usually corresponds to a condition of the new. Before installation on the engine be not too lazy to clean once again carefully a head, having completely removed metal sawdust, traces of an abrasive and other small production garbage from all her cavities and channels. Blow all channels and openings compressed air (do not forget to put on goggles).